User Tools

Site Tools


steering_angle_sensor:start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
steering_angle_sensor:start [2019/04/16 02:32]
87yj [Wheel Angle Sensor]
steering_angle_sensor:start [2019/04/29 08:27] (current)
jaw896 [Using a 16 bit ADC to read the Wheel Angle Sensor]
Line 61: Line 61:
 - The Ability of the ADS1115 to read the Signal in a Differential Mode allows you to read Factory Installed Sensors, which are connected to the Tractor, in a Ground floating Way, this prevents setting fault codes in the tractor software. Differential means the ADS just measures the difference between two wires, not between Arduino Ground and a wire. - The Ability of the ADS1115 to read the Signal in a Differential Mode allows you to read Factory Installed Sensors, which are connected to the Tractor, in a Ground floating Way, this prevents setting fault codes in the tractor software. Differential means the ADS just measures the difference between two wires, not between Arduino Ground and a wire.
  
-- Also with AOG-dedicated Wheel Angle Sensors you will get a clear signal, because the electric interferences at the wires could be eliminated. The ADC must be placed as close to wheel angle sensor as possible though to keep the analog sense wire as short as possible. 
  
 Schematics and Code at [[http://​github.com/​Coffeetrac]] (the Hires version) Schematics and Code at [[http://​github.com/​Coffeetrac]] (the Hires version)
 ---- ----
  
steering_angle_sensor/start.txt ยท Last modified: 2019/04/29 08:27 by jaw896